Repeater Systems Accessories: RP-4 Plus

RP-4 Plus
COR / Repeater Control

RP-4 PLUS. Repeater control unit RP-4 PLUS can make a repeater with just any two transceivers. Typical connections: Discriminator or COS microphone or TX flat input, PTT, +12VDC and ground. Has ajustable hang time and connections for encoder/decoder CTCSS. Small size 3 1/2" x 3" x 1 5/8" comes in a metal cabinet to prevent interections with the radios. Ready to connect to your radios trough a DB9 female connector. A DB 15 male included.

RP-4 PLUS. Repeater control, includes cabinet. Price: $123.00 Dls.

RP-4. Only Board. Price: $111.00 Dls.


WE SUGGEST THE FOLLWING CABLES:

KRR-15D. Interface cable for Kenwood radios. Price: $45.00 Dls.

KRR00-15D. Interface cable for TK7100 / 8100. Price: $45.00 Dls.

GRR-15D. Interface cable for other radios. Price: $45.00 Dls.





"COR" EXPRESS
Controls





Now you get from SYSCOM a COR ready to make repeaters in a metter of seconds. Simple plug in the back connectors of two radios and the will works as a repeater. The COR comes pre-calibrated. It also woks as a double repeater if you wish. This is the most economic ans fastest way to get an operating repeater. With KTS-10 is possible to install repeaters anywhere, including inside of offices to convert the Base Station in mini-repeater andthus use portables as remote stations. The same applies to ranches, factories, etc. where it is difficult to haven an operator next to the base station.

KTS00-10. For TK7100 / 8100 radios it does not require connector of accessories. Price: $89.00 Dls.

KTS-10. For Kenwood radio.-Accessory connector not required. Price: $85.00 Dls.


MANUFACTURE REPEATERS IN A MATTER OF SECONDS!

Note: ICOM IC-F320 & IC-F420 do not require a RP4, because it is already enclosed into the radios.
The ITS-10 is enough.